Installing drywall is as much of a science as an art. A lot of mistakes occur, especially when handled by those not skillful with it. Missing a detail or two is easy when installing drywall. And this can make the project get out of hand quickly. You don’t want to waste your money and time and still get subpar results.
This guide presents to you some common errors that occur during drywall installation, and how to avoid them. Read on.
Common Drywall Installation Errors and How to Avoid Them
Several mistakes occur when installing drywall. Here are four of the common ones and how to prevent them.
Missing edge support
Installing drywall on the ceiling can be a bit tricky. Supporting the edges is very vital. Properly fastening the drywall won’t ease.
Ensure that you always examine the framing, which is essential, especially before putting up the drywall. At every corner, at least an inch of exposed framing is needed.
It’s also important to check along the drywall’s top lined up parallel with the ceiling frame. This can be missing at times, pay attention. You also need to include blocking. To do this, screw at an angle if a hammer isn’t available.
Neglecting cutting tapered edges
Your plan won’t work if you cut a drywall too tight. The drywall’s interior will crumble at the edges. It may also chip out at the corner. You don’t want to remove the sheet and start from scratch again. It’s not worth it.
To avoid this error, simply leave a gap of about one-eighth inch on every edge. This allows proper tapering. It’s easier and better to fill the gaps than to replace the whole drywall sheet.
Too many joints
Your project becomes more difficult with too many joints. That’s more work for you. You’ll be handling and taping more sheets if you make this mistake. More tendency for errors is likely to occur with too many joints
How do you avoid this? Use the longest and largest drywall sheets available. You don’t need to bother about the cost as this material is affordable. And it will save you more time.
Not trimming before fastening
Some outlet holes won’t fit exactly as they were cut. This is common. The first thing to do when you observe this error is to trim the opening of the drywall. Fastening can follow. If fastening is done before trimming, the drywall may break during trimming, especially around an electrical box
Fastening the sheet with a couple of screws away from the opening of the outlet before trimming is fair. However, it’s better to avoid fastening until the hole(s) is correct. This saves you time.
Conclusion
Making errors during drywall installation can be expensive as you’ll need to buy new materials. You want to avoid making these common mistakes at all costs.
These tips should help you, even as a first-time drywall installer. You will be able to easily avoid or understand how to fix errors that might occur while working on your drywall project. Finally, reach out epoxy for the drywall installation and flooring.
